Yamaha LL16M Rescue & Upgrade

Worked on this LL16M a couple of weeks back.

IMG_6455

The guitar came to me badly in need of help. The owner had brought it to a shop situated in our local guitar hub for a bone saddle & nut upgrade but it turned out to be a total nightmare.

IMG_6456

Here’s a look at the solid mahogany body. It’s less striking than the rosewood sibling, but I can tell you the mahogany is definitely a great tone wood.

According to the owner, the shop had installed saddle and nut that were off-specs. Saddle was too short (generic 72mm vs  Yamaha spec 75mm) and moved in the slot, nut was too narrow (generic 43mm vs Yamaha L Series spec 44mm) screwing up string spacing.

Here you can see that the nut has an allowance of about 1mm on ether side. This threw off all specs and feel of the LL16M neck.

IMG_6458

IMG_6459

Guitarbear was appalled by the incident. Upon seeing the guitar, I feel very upset that someone would actually do that to nice guitar. If you don’t have the parts or the know-how/skills, please DON’T ruin other people’s guitar. 

Removing the blotched job and putting in the correct part. 

First step to this rescue operation was to remove this horrendous nut. Plenty of staged photos here, but how else could I show you? 🙂

IMG_6460

I used a hairdryer to heat up the glued area so that it’d be easier to remove the “cancerous object”.

IMG_6462

I used a small square chip board to gently tap out the nut. Again, this is a staged photo. 

IMG_6463.JPG

Plenty of glue residue. There must have been a huge wad of superglue used. Whoever he/she is, the person who worked on the guitar is a loser. I wouldn’t let this loser come near my guitars even if you pay me.

IMG_6497

Next I used 600 grit sandpaper to smooth out the nut slot for installation of new nut. You need to remove the glue residue to ensure a flat surface for the new nut.

IMG_6465

The owner had to go all the way to Yamaha service centre to buy a new nut. Although it’s a plastic part, it is far better than one that was off-specs.

See the comparison photo. The differences in string spread and size are obvious.

IMG_6464

Fast forward to show how much better the stock Yamaha nut looks and feel.

IMG_6473

This is the right way to do things.

Dropping in a bone saddle

IMG_6467

Time to shape a new bone saddle. Careful sanding and adjustments are done to get the best height and radius.

IMG_6468

Final sanding using 2000 grit to get that smooth finish.

IMG_6469

OK, we got a nice bone saddle installed. Owner also brought a set of bone pins for this.

Tip: Yamaha guitars use 75mm saddles, not 72mm.

Again, the same photo to show how important it is to have correct parts (dimensions) if you cannot craft them out from blanks.

Tip: Yamaha plastic nut for L series. 44mm, string spread is about 36-37mm.

IMG_6473

Final clean up with Bearclaw Special. Guitar was shiny and happy. Action set up just slightly under 5/64 inch at 12th fret capo on 1.

Super playability and great sounds. Roger is smiling.

IMG_6470

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s